Table of Contents
Advertisement
Unpacking and Installing the Controller
Unpacking and Installing the Controller
Follow these steps to unpack the Cisco 5500 Series Wireless Controller and prepare it for operation:
Step 1
Open the shipping container and carefully remove the contents.
Step 2
Return all packing materials to the shipping container and save it.
Step 3
Ensure that all items listed in the
Check each item for damage. If any item is damaged or missing, notify your authorized Cisco sales
representative.
Package Contents
Each access point package contains the following items:
•
•
•
•
•
Required Tools and Information
You will need the following equipment in order to install the controller:
•
•
•
You will need the following tools before you can install the controller:
•
•
Cisco 5500 Series Wireless Controller Installation Guide
8
Cisco 5500 Series Wireless Controller and power cord
Mounting hardware kit
Regulatory Compliance and Safety Information for the Cisco 5500 Series Wireless Controller
This guide
Cisco product registration and Cisco documentation feedback cards
Wireless LAN controller hardware
Controller with factory-supplied power cord and mounting hardware
–
Network, operating system service network, and access point cables as required
–
Command-line interface (CLI) console
VT-100 terminal emulator on CLI console (PC, laptop, or palmtop)
–
Null modem serial cable to connect CLI console and controller
–
Local TFTP server (required for downloading operating system software updates). Cisco uses an
integral TFTP server. This means that third-party TFTP servers cannot run on the same workstation
as the Cisco WCS because Cisco WCS and third-party TFTP servers use the same communication
port.
#2 Phillips screwdriver for securing the mounting hardware
#1 Phillips screwdriver for securing captive installation screws on the power supply and fan
"Package Contents" section on page 8
are included in the shipment.
78-18998-01
Hide quick links:
Advertisement
Table of Contents
