Data/Event Requests; Transmit/Receive Data - Lexicon LXP-5 - REV 1 Owner's Manual

LXP-5 Owner's Manual
Event Requests
Byte Value
0 F0 (hex)
1 06
2 05
3 0110 nnnn(bin)
4 0eee eeee
5 0ppp pppp
6 F7 (hex)

Transmit/Receive Data

Data is identical in format whether transmitted as a response to a Data
Request or received as a Data Dump.
When the front panel ADJUST knob is assigned to a parameter and turned,
the LXP-5 will transmit a parameter change message reflecting the new
position of the knob (See Parameter Adjust for the format.). The transmitted
parameter number will reflect the specific parameter to which the knob is
assigned. Changing a parameter in Edit mode will also cause a parameter
change mesage to be sent. Recalling a program with the front panel
FUNCTION or ADJUST knobs will cause the appropriate program parame-
ter change message to be sent.
Two LXP-5s can be slaved together by connecting a cable from the MIDI
OUT jack of the master to the MIDI IN jack of the slave . Additional LXP-5s
can be slaved to the same master by connecting a cable from the MIDI THRU
port of one unit to the MIDI IN port of the next unit.
Remember, since one jack serves as both MIDI THRU and MIDI OUT on the
LXP-5, be sure the rear panel switch is in the appropriate position.
All LXP-5s must be set to the same MIDI Channel.
4-2
Description
System Exclusive
Lexicon ID
LXP-5 ID
n = MIDI Channel 0-15
e = event code:
70h = store current edit to register
71h = recall program to edit buffer
p = register number 0 - 127
End of SysEx message