Lexicon LXP-5 - REV 1 Owner's Manual page 33

LXP-5 Owner's Manual
Choosing ADJUST Knob Destination
After creating a sound, you can customize your effect by assigning as many
as five parameters to the ADJUST knob. This allows you to recall a program,
and modify the chosen parameters with the ADJUST knob without going
back into Edit mode.
Assignment of ADJUST must be done while in Edit mode. Turn FUNCTION
to EDIT B and SELECT to position 13. The following table shows the
parameters which can be assigned to ADJUST:
FUNCTION
EDIT B
If a parameter is chosen which is unavailable in the selected program,
ADJUST will have no audible effect. If a parameter is not selected for
ADJUST while in Edit mode, it will maintain its current parameter assign-
ment.
2-18
SELECT ADJUST Assigned Parameter
13 MIN Delay 1 — Coarse
2 Feedback 1
3 Delay 2 — Coarse
4 Feedback 2
5 Delay 3 — Coarse
6 Pitch Interval
7 Decay Time
8 Treble Decay
9 Size*
10 High Cut Filter
11 Low Cut Filter
12 Reverb Balance
13 Input Level
14 Output Level
15 Output Balance
MAX LFO Rate
* Altering the Size parameter in real-time
will cause the LXP-5 to mute briefly.