Procom QL300TYLA Owner's Operation And Installation Manual

Procom QL300TYLA Owner's Operation And Installation Manual

Compact l.p.& natural gas vent-free stove

Advertisement

OWNER ' S OPERATION AND INSTALLATION MANUAL
QN300TYLA QL300TYLA
QN220TYLA QL220TYLA

Table of Contents

Safety information warnings----------------------2
Installation----------------------------------------------6
Installing Blower Accessory---------------------10
Troubles hooting-------------------------------------15
Parts Breakdown & Parts List------------------18
Log Placing Instructions--------------------------22
WARNING: If the information in this
manual is not followed exactly,a f i r e o r
e x p l o s i o n m a y r e s u l t causing property
damage, personal injury, or loss of life.
WARNING:
This is an unvented gas-
fired heater. It uses air (oxygen) from the
room in which it is installed. Provisions
for adequate combustion and ventilation
air must be provided. Refer to Air For
Combustion and Ventilation section on page
4 of this manual.
CINTINENTAL APPLIANCE INC
5 Musick
Irvine
CA 92618
TOLL-FREE NUMBER: 1-877-886-5989
4600 Highlands Parkway S.E
.
Suite # D/E
Smyrna, GA 30080
COMPACT L.P.& NATURAL
GAS VENT-FREE STOVE
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do
not
touch
use any phone in your building.
Immediately
call
neighbor's phone. Follow the gas supplier's
instructions.
the fire department.
Installation and service must be performed by a
qualified installer, service agency, or local gas
supplier.
WARNING: Improper installation, adjustment,
alteration, service or maintenance can cause in-
jury or property damage. Refer to this manual for
correct installation and operational procedures. For
assistance or additional information consult a
qualified installer, service agency, or local gas supplier.
This appliance may be installed in an aftermarket*,
permanently located manufactured (mobile) home,
where not prohibited by local codes.This appliance
is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use
with other gases.
WATER VAPOR:A BY-PRODUCT OF UNVENTED ROOM
HEATERS
Water vaporis a by-product of gas combustion.An unvented
room heater produces approximately one(1)ounce (30)ml
of water for every 1,000BTU'S (3KW'S) OF gas input per
hour,Refer to papg 6.
Consumer : please retain these instruction for
future use.
Installer:Please leave these instructions with the
consumer.
*Aftermarket: Completion of sale, not for purpose of resale,
from the manufacturer.
1
any
electrical
switch; do not
your gas supplier from a

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the QL300TYLA and is the answer not in the manual?

Questions and answers

Summarization of Contents

Product Features
Safety Pilot
Features Oxygen Depletion Sensing (ODS) safety shutoff system for vent-free heaters.
Piezo Ignition System
Describes the piezo ignitor system requiring no matches or batteries for lighting.
Air for Combustion and Ventilation
Providing Adequate Ventilation
Instructions on ensuring sufficient fresh air for combustion and ventilation for the heater.
Determining Fresh-Air Flow for Heater Location
Worksheet to determine if the installation space is confined or unconfined.
Ventilation Air From Inside Building
Methods to supply fresh air from adjoining rooms via openings or door removal.
Ventilation Air From Outdoors
Methods to supply fresh air directly from outdoors using vents or ducts.
Installation
Minimum Clearance to Wall and Ceiling
Specifies required clearances from the stove to walls and ceiling for safe operation.
Connecting to Gas Supply
Instructions for safely connecting the heater to the gas supply, including regulator requirements.
Installation Items Needed
Lists essential components and tools required for the heater installation.
Checking Gas Connections
Pressure Testing Gas Supply Piping System
Procedure for testing gas supply piping for leaks under specific pressure conditions.
Pressure Testing Heater Gas Connections
Procedure for testing connections between the heater and gas supply for leaks.
Test Pressures Equal To or Less Than 1/2 PSIG(3.5 kPa)
Procedure for testing gas connections at lower pressure levels.
Operating Heater
Read Before Lighting
Crucial safety information and steps to follow before attempting to light the heater.
To Turn Off Gas To Appliance
Procedure for safely shutting off the gas supply to the appliance.
Thermostat Control Operation
Details on adjusting the thermostat for desired comfort levels and heat output.
Manual Lighting Procedure
Alternative method for lighting the pilot using a match if the ignitor fails.
Inspecting Burners
Guidance on checking pilot flame and burner flame patterns for correct operation.
Cleaning and Maintenance
Cleaning Burner Injector Holder and Pilot Air Inlet Hole
Instructions for cleaning air inlet holes to ensure clean burning and prevent soot.

Table of Contents

Save PDF