NETGEAR SSL312-100NAS - ProSafe SSL312 SSL VPN Concentrator 25 User Manual page 93

Figure 7-2
2. Enter the Ethernet Port 1 subnet mask that has been configured for your network. The subnet
mask value should be the same value as the subnet mask configured on your network
computers. The factory default is 255.255.255.0 (The subnet mask specifies the network
number portion of an IP address.).
3. Only if you plan to use two port mode, enable routing mode by checking this checkbox. The
second Ethernet port will be enabled.
Note: NETGEAR recommends one port operation for most networks.
4. Enter a local or internal IP address of your ProSafe SSL VPN Concentrator 25. This address
should be in a different subnet than the Ethernet Port 1 IP address. The default Ethernet Port 2
IP Address is 10.0.0.1.
Additional System Configuration
NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
v2.1, November 2008
7-3