NETGEAR SSL312-100NAS - ProSafe SSL312 SSL VPN Concentrator 25 User Manual page 95

To configure a static route:
1. In the Add Static Routes section, enter the destination network address of the static route in the
Destination Network field. The destination network address is an IP address in the remote
network subnet.
Note: The destination network address may be a valid IP address or it may be a
subnet address that ends in .0, such as 192.168.0.0.
2. In the Subnet Mask field, enter the subnet mask of the remote network segment.
3. In the Gateway Address field, enter the IP address of your router. The gateway address should
be in the same subnet as the ethernet-1 or ethernet-2 interface.
For example, if the ethernet-1 interface address is 10.0.0.100 and the subnet mask is
255.255.255.0, then a router connected through the ethernet-1 interface should be 10.0.0.X.
4. From the Interface menu (ethernet-1 or ethernet-2), select the Ethernet interface that should be
used to connect to the gateway address.
5. Click Apply. The new static route is added to the Routes table.
Note: To add additional local subnets that can directly connect to the ProSafe SSL
VPN Concentrator 25 device, define the Destination Network address, the
Subnet Mask, and the Interface, but leave the Gateway Address field blank.
Additional System Configuration
NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
v2.1, November 2008
7-5