Table of Contents
Advertisement
Caution
Make certain that you are properly grounded when you handle components internal to
the appliance to protect against electrostatic discharge damage to the appliance. Use
the grounding wrist strap included in the battery replacement kit.
To install the battery
1. Use Network Voyager or the CLI to halt the appliance.
To use Network Voyager to shut the appliance down, select
System > Configuration > Reboot or Shutdown > Halt.
To use the CLI to shut the appliance down, enter halt at the prompt.
2. Remove the power cord from the IP150 appliance, and remove the appliance from the rack.
3. Turn the appliance right-side up and place it on a safe and protected work surface.
4. Remove the three top-cover screws and slide the cover back to remove it from the appliance.
Nokia IP150 Security Platform Installation Guide
Replacing the Battery
00667
59
Advertisement
Table of Contents
