Table of Contents
Advertisement
Caution
To protect the appliance and the encryption accelerator card from electrostatic
discharge damage, make sure you are properly grounded before you touch these
components. Use a grounding wrist strap and follow the instructions provided with the
wrist strap before you handle the components or open the appliance. If you do not have
a grounding wrist strap, make sure you are properly grounded before you touch any
electronic component.
You must perform an orderly shutdown of the appliance and turn the power off whenever you
remove the chassis tray assembly to service internal components.
Before You Start
To install or replace the encryption accelerator card in your appliance, you need the following:
Physical access to the appliance
A Nokia-approved encryption accelerator card
Access to the appliance through Network Voyager
A Phillips-head screwdriver
To install or replace a Nokia encryption accelerator card
1. Use Network Voyager or the CLI to halt the appliance.
To use Network Voyager to shut the appliance down, select
System > Configuration > Reboot or Shutdown > Halt.
To use the CLI to shut the appliance down, enter halt at the prompt.
2. Remove the power cord from the IP150 appliance, and remove the appliance from the rack.
3. Place the appliance right-side up and place it on a safe and protected work surface.
Nokia IP150 Security Platform Installation Guide
Installing or Replacing the Nokia Encryption Accelerator Card
55
Advertisement
Table of Contents
