Before You Start - Nokia NBB0150000 - IP150 - Security Appliance Installation Manual

Note
Back up your files to a remote system on a regular basis. For back up and restore
procedures, see the Getting Started Guide and Release Notes for the version of Nokia IPSO
you are using.

Before You Start

To replace the hard-disk drive in your appliance, you need the following:
Physical access to the appliance
A Nokia-approved hard-disk drive
Access to the appliance through Network Voyager
A Phillips-head screwdriver
To replace a hard-disk drive
1. Use Network Voyager or the CLI to halt the appliance.
To use Network Voyager to shut the appliance down, select
System > Configuration > Reboot or Shutdown > Halt.
To use the CLI to shut the appliance down, enter halt at the prompt.
2. Remove the power cord from the IP150 appliance, and remove the appliance from the rack.
3. Place the appliance right-side up and place it on a safe and protected work surface.
4. Remove the three top-cover screws and slide the cover back to remove it from the appliance.
5. Locate the hard-disk drive installation location and disconnect the two connectors from the
drive.
Nokia IP150 Security Platform Installation Guide
Replacing a Hard-Disk Drive
00667
47