Connecting Power And Turning The Power On; Figure 10 Power Switch Location - Nokia NBB0150000 - IP150 - Security Appliance Installation Manual

4
9600 bps
8 data bits
No parity
1 stop bit
To connect to the console
1. Connect the supplied null-modem cable (console cable) to the console port on the front
panel of the IP150 appliance.
If you connect the console port to a data communications equipment (DCE) device, use a
straight-through cable.
For cable pin assignments for the console connection, see
2. Connect the other end of the cable to the VT100 console or to a system running a
terminal-emulation program.

Connecting Power and Turning the Power On

A power switch and a receptacle for the power cord are located on each power supply on the
back of the appliance as shown in

Figure 10 Power Switch Location

32
POWER
STATUS
FAULT
AUX CONSOLE
Console port
Figure
1 2 3 4
Figure 4
10.
Power plug
Nokia IP150 Security Platform Installation Guide
IP150
00662
on page 17.
00663
Power switch