Table of Contents
Advertisement
5
To enable IKE acceleration
1. From the Network Voyager home page, click Security and Access Configuration, then click
IKE Acceleration.
For information about how to access Network Voyager and the related reference materials,
see
2. On the IKE Acceleration page, click Register the module.
3. Click Apply.
The PKCS#11 token that enables IKE acceleration is registered with the Check Point software
on your appliance. After you register the module, you must install the Check Point security
policy on the firewall for the Nokia encryption accelerator card to perform IKE acceleration.
Replacing the Battery
Caution
To protect the appliance from electrostatic discharge damage, make sure you are
properly grounded before you touch these components. Use a grounding wrist strap
and follow the instructions provided with the wrist strap before you handle the
components or open the appliance. If you do not have a grounding wrist strap, make
sure you are properly grounded before you touch any electronic component.
You must perform an orderly shutdown of the appliance and turn the power off whenever you
remove the chassis tray assembly to service internal components.
To replace the battery, you need the following:
The appropriate Nokia battery replacement kit for your appliance
Physical access to the appliance
A Phillips-head screwdriver
A grounding wrist strap
(Optional) Safety glasses
Warning
Risk of explosion if battery is replaced by an incorrect type. Replace the battery only with the
same or equivalent type that the manufacturer recommends. Dispose of used batteries
according to the manufacturer's instructions.
Warning
Make certain to remove the power cord from the appliance before you proceed with any of
the following steps. Failure to do so could cause electric shock with burns or death resulting
for the user.
58
"Using Nokia Network Voyager"
on page 35.
Nokia IP150 Security Platform Installation Guide
Advertisement
Table of Contents
