Power Management; Setting Power Options; Using Power-Saving States; Initiating And Exiting Standby - HP 1035nr - Mini - Atom 1.6 GHz User Manual

2

Power management

Setting power options

Using power-saving states

The device has two power-saving states enabled at the factory: Standby and Hibernation.
When Standby is initiated, the power light blinks and the screen clears. Your work is saved to memory.
Exiting Standby is faster than exiting Hibernation. If the device is in Standby for an extended period or
if the battery reaches a critical battery level while in Standby, the device initiates Hibernation.
When Hibernation is initiated, your work is saved to a hibernation file on the hard drive and the device
turns off.
CAUTION:
functionality, or loss of information, do not initiate Standby or Hibernation while reading from or writing
to a disc or an external media card.
NOTE: You cannot initiate any type of networking connection or perform any device functions while
the device is in Standby or in Hibernation.

Initiating and exiting Standby

The system is set at the factory to initiate Standby after 10 minutes of inactivity when running on battery
power and 25 minutes of inactivity when running on external power.
Power settings and timeouts can be changed using Power Options in Windows Control Panel.
With the device on, you can initiate Standby in any of the following ways:
●
Press fn+f1.
●
Click Start > Turn Off Computer > Stand By.
To exit Standby:
Briefly slide the power switch.
▲
When the device exits Standby, the power light turns on and your work returns to the screen where
you stopped working.
NOTE: If you have set a password to be required when the device exits Standby, you must enter your
Windows password before your work will return to the screen.
To prevent possible audio and video degradation, loss of audio or video playback
Setting power options 11