Installation Instructions - Lexicon 960L V3.0 - INSTALLATION AND RELEASE NOTES REV 4 Installation Instructions Manual

Installation Instructions & Release Notes

INSTALLATION INSTRUCTIONS

Note:
Although the installer will preserve user registers, it is recommended to save them to disk
before installing the software upgrade. (See the Organizing Your Registers section in
Chapter 4 of the owner's manual for more information.) These saved user registers will
be compatible with the current software version in the 960L. If necessary, saved user
registers can be loaded from the disk to the Software Version 3.0 system. However, it is
recommended to save a copy of current user registers in case it is ever desired to revert the
system back to its current software version. (See the Reverting to a Previous Software
Version section on page 7.)
Performing this upgrade is a simple process. But to avoid problems, please follow the instructions
carefully. Pay particular attention to precautions that appear throughout this document.
Please note the following before proceeding to the steps below:
• This bullet can be ignored if the 960L is currently running Software Version 2.4 or above.
Otherwise, the installation process will require the 960L serial number, which is located on the
back of the mainframe. The serial number consists of four digits, followed by a dash, followed by
four more digits. It is recommended to note this number before beginning installation. (The unit
will not ask to have the serial number re-entered if this process was completed during a previous
installation.)
• Refer to the 960L Owner's Manual for instructions to open the 960L front panel.
• Use the front panel standby button whenever the instructions call for the 960L to be powered on
or off. Do not use the rear panel power switch.
• It is recommended to read the 960L Owner's Manual and Owner's Manual Addenda to get the
most from the 960L.
• The installation process will take about 15 minutes.
These service instructions are for use by qualified personnel only. Do not perform
WARNING
any servicing other than that contained in these instructions unless qualified to do
so. Refer to safety instructions prior to performing any service.
1. While the 960L is powered on, insert the Software Version 3.0 CD. Using the front panel standby
button, power off the system, wait a few seconds, then power on the system again. After a few
minutes, the following message will appear:
Install disc found in drive – [960L V3.00R]
Update / Install 960L: press '1' to install
4
press '0' to continue with no install
Lexicon