Table of Contents
Advertisement
Installation Instructions & Release Notes
This document contains installation instructions for the 960L Version 2.40 Software. It
describes updated and enhanced features of Version 2.40, and discusses items that did not
receive full coverage in the Owner's Manual. Please refer to the 960L Owner's Manual for
additional information.
INSTALLATION INSTRUCTIONS
Note:
Although the installer will preserve user registers, it is recommended to save them to a
floppy disk before making the upgrade. (See the section called Organizing Your Registers
in Chapter 4 of the Owner's Manual.) These saved user registers will be compatible with
the current version of software in the 960L. If necessary, saved user registers can be
loaded from the floppy disk to the Version 2.40 system. However, it is recommended to
save a copy of the current user registers in case it is ever desired to revert the system back
to its current version. (See Reverting to a Previous Software Version on page 6.)
Performing this upgrade is a simple process. But to avoid problems, please follow the
instructions carefully. Pay particular attention to precautions that appear throughout this
document.
Please note the following before proceeding to the steps below:
•
The installation process requires the 960L serial number, which is located on the back of
the mainframe. It is recommended to note the serial number before beginning
installation.
•
The installation process will take approximately 15 minutes.
1. While the 960L is powered up, insert the Version 2.40 CD. Power down the system, wait
a few seconds, then power back up. After a few minutes, the following message will
appear:
Install disc found in drive — [960L V2.40R BUILD 1]
Update / Install 960L: press '1' to install
2. Press 1 to begin installation. A number of progress messages will appear. When this
phase of installation is complete (after about one minute), the following message will
appear:
Install complete. Please remove CD from drive.
4
press '0' to continue with no install
Lexicon
Advertisement
Table of Contents
Need help?
Do you have a question about the 960L V2.40 - INSTALLATION AND RELEASE NOTES REV 2 and is the answer not in the manual?
Questions and answers