Table of Contents
Advertisement
960L Software Version 3.0
2. Press 1 to begin installation. A number of progress messages will appear. When this phase of
installation is complete (after about 1 minute), the following message will appear:
Install complete. Please remove CD from drive.
3. Remove the CD from the drive. Using the front panel standby button, power off the system, wait
a few seconds, then power on the system again. The 960L will take a little longer to boot than
normal.
If the LARC2 requires an update, the following menu will appear on the LARC2 display:
Update needed on Larc2: Press '1' to update
4. Press 1 to begin the LARC2 update. This is the longest phase of the process, lasting about 10
minutes. The LARC2 will display a progress indicator. If the 960L is currently running Software
Version 2.4 or above, skip ahead to step 7 (page 6). If not, proceed to step 5 (below).
5. After the LARC2 update is complete, the following message may appear:
Please enter serial number of the 960L from the back panel of the
960L chassis. Do not use the serial number of the LARC2!
Enter numbers only. Do not enter first letter (shown as 'x')
Use minus for '-' : Use left arrow '<' for backspace : Finish with
ENTER.
x_
Enter the serial number as it appears on the rear panel of the 960L mainframe. Do not enter the
first letter. Enter the numbers and the dash only. Press ENTER when finished. The following
message will appear:
Please re-enter serial number for verification . . .
x_
Note:
When installing Software Version 3.0, the unit will not ask to have the serial number
re-entered if this process was completed during a previous installation.
Installation Instructions & Release Notes
Press '0' to ignore
. . . Installation Instructions continues on page 6
5
Advertisement
Table of Contents
Need help?
Do you have a question about the 960L V3.0 - INSTALLATION AND RELEASE NOTES REV 4 and is the answer not in the manual?
Questions and answers