Advertisement
960L Version 2.40 Software
RELEASE NOTES
The list below includes features of the 960L Software Version 2.40 that are not fully covered
in the Owner's Manual:
•
When configuring systems with two DSP cards, there are no longer two soft buttons
labeled CONFIG 1 and CONFIG 2. In Version 2.40, there is one soft button labeled
"CONFIG v." When pressed, a menu will appear allowing selection of the DSP card for
configuration. In systems with one DSP card, there is no change.
•
The ability to use double-button presses to access options has been removed in order to
support future functionality.
•
Reverb algorithms now allow input levels to be set to a maximum level of 0dB. In
previous releases –6dB was the maximum.
Note:
Setting the input level above –6dB can result in DSP overflows.
•
When processing audio, loading a very small Random Hall program while running a large
Random Hall program (i.e. loading Oil Drum while running Large Hall) may generate DSP
feedback. The level and duration of this feedback is dependent on the audio source. To
prevent feedback from occurring, mute the machine before loading the smaller Random
Hall program.
•
Parameters with an OFF position in the center of the fader travel can now be set to OFF
by pressing and holding the FINE ADJ button and lightly touching the desired fader.
•
Several banks of factory delay programs are visible, but not loadable, in the Version 2.40
software. To load these programs, upgrade to the 960L Version 2.50 software.
•
Occasionally, LARC2 motorized faders may exhibit a "vibrating" characteristic when
settling into a new position as programs are loaded. This characteristic may appear to be
inconsistent from fader to fader. This is normal due to the varying characteristics of
individual fader components. The faders will settle into a stable position after a short
adjustment or calibration period.
Installation Instructions & Release Notes
7
Advertisement
