Table of Contents
Advertisement
Installation Instructions & Release Notes
RELEASE NOTES
The list below includes features of the 960L Software Version 2.4 that are not fully covered in the
owner's manual:
•
When configuring systems with two DSP cards, there are no longer two soft buttons labeled
CONFIG 1 and CONFIG 2. In Version 2.4, there is one soft button labeled CONFIG v. When
pressed, a menu will appear allowing selection of the DSP card for configuration. In systems
with one DSP card, there is no change.
•
The ability to use double-button presses to access options has been removed in order to
support future functionality.
•
Reverb algorithms now allow input levels to be set to a maximum level of 0dB. In
previous releases –6dB was the maximum.
Note:
Setting the input level above –6dB can result in DSP overflows.
•
When processing audio, loading a very small Random Hall program while running a large
Random Hall program (i.e. loading Oil Drum while running Large Hall) may generate DSP
feedback. The level and duration of this feedback depends on the audio source. To prevent
feedback from occurring, mute the machine before loading the smaller Random Hall
program.
•
Parameters with an OFF position in the center of the fader travel can now be set to OFF by
pressing and holding the FINE ADJ button and lightly touching the desired fader.
•
Several banks of factory delay programs are visible, but not loadable, in the Version 2.4
software. To load these programs, upgrade to the 960L Version 2.5 software.
•
Occasionally, LARC2 motorized faders may exhibit a "vibrating" characteristic when
settling into a new position as programs are loaded. This characteristic may appear to be
inconsistent from fader to fader. This is normal due to the varying characteristics of
individual fader components. The faders will settle into a stable position after a short
adjustment or calibration period.
•
Input/output routings need to be set after installing Version 2.4. Once set, the input/output
routings are saved with the configuration and will be automatically recalled when that DSP
configuration is loaded.
•
Input/output routings saved with each configuration may become invalid if the order of the
input/output cards is changed or if an input/output card is removed from the unit. If this
occurs, simply reset the input/output routings.
6
Lexicon
Advertisement
Table of Contents
Need help?
Do you have a question about the 960L V2.4 - INSTALLATION AND RELEASE NOTES REV 3 and is the answer not in the manual?
Questions and answers