Lexicon 960L V2.40 - INSTALLATION AND RELEASE NOTES REV 2 Installation Instructions Manual page 5

960L Version 2.40 Software
3. Remove the CD from the drive. Power down the system, wait a few seconds, then power
back up. The 960L will take a little longer to boot than normal.
If the LARC2 requires an update, the LARC2 will display the following menu:
Update needed on Larc2: Press '1' to update
4. Press 1 to begin the LARC2 update. This is the longest phase of the process, lasting about
10 minutes. The LARC2 will display a progress indicator. After the LARC2 update is
complete, the following message will appear:
Please enter serial number of the 960L from the back panel of
the 960L chassis. Do not use the serial number of the LARC2!
Enter numbers only. Do not enter first letter (shown as
Use minus for
with ENTER.
x_
Note:
When reinstalling Version 2.40, the unit will not ask to have the serial number re-
entered if this process was completed during a previous installation.
5. Enter the serial number as it appears on the back panel of the 960L mainframe. Do not
enter the first letter. Enter the numbers and the dash only. Press ENTER when finished. The
following message will appear:
Please re-enter serial number for verification . . .
x_
6. Enter the serial number again as it appears on the back panel of the 960L mainframe.
Once again, do not enter the first letter of the serial number. Enter the numbers and the
dash only. Press ENTER when finished and the system will start.
7. After the system has started, verify that the software has been installed properly. To do
this, press the CONTROL button, then the SYSTEM button, and read the version
information on the screen. The LARC2 version is 2.40 and the mainframe version is 2.40.
Once this process is complete, configure the system and continue working. It is
recommended to read the 960L Owner's Manual to make the most of the 960L.
Installation Instructions & Release Notes
Press '0' to ignore
- : Use left arrow < for backspace : Finish
x )
5