Lexicon 960L - ADDENDUM Owner's Manual Addendum page 9

960L
Grain
Provides extended control of diffusion in the
input path. A low setting produces a tight
smear pattern (perhaps only discernable with
percussion). A large setting produces a more
widespread pattern.
Hold
Provides infinite hold for audio in delays. Each
delay loops at its delay length. When Hold is
set to ON, no input signal is admitted into the
delay. Voices can still be panned, and filters
and gains can still be adjusted. Output
adjustments made to the DelMST or Fbk
parameters will not take effect until the Hold
parameter is set to OFF.
For Random Delays, the Hold parameter
functions as described above, except that only
Voice 1 is recirculated. The output from all
voices is still available.
InLvl
Controls input level. Normally, this parameter
can be set to 0dB. But high levels of diffusion
or strong low-frequency content may require a
setting of -6dB or lower.
LvlMST
Controls the level of all delays.
Mix
Controls the wet-to-dry mix ratio.
Mod1, Mod2
Modify Randomizer 1 and Randomizer 2. The
setting can be a threshold or a rate, depending
on the Rand1, Rand2 parameter setting.
Delays & Additional 96kHz Reverbs Package
Rand1, Rand2
Select the randomizer type for Randomizer 1
and Randomizer 2. When set to SloRand, one
delay voice is changed at a time at the rate
specified by the Mod1, Mod2 parameter.
When set to FstRand, all delay voices are
changed at once at the rate specified by the
Mod1, Mod2 parameter. When set to Gate,
wander time is added to all delay voices
whenever input level rises above the threshold
specified by the Mod1, Mod2 parameter.
When set to –Gate, wander time is added to
all delay voices whenever input level falls
below the threshold specified by the Mod1,
Mod2 parameter.
V1Rand, V2Rand, V3Rand
Designate the randomizer that affects all Voice
1s (ones), Voice 2s (twos), and Voice 3s
(threes). Voices can be assigned to Randomizer
1, Randomizer 2, or no randomizer at all.
Wand1, Wand2
Specify the amount of delay added to voices
affected by Randomizer 1 and Randomizer 2.
When the Rand1, Rand2 parameter is set to a
gate mode, the full amount is added. When
the Rand1, Rand2 parameter is set to a rand
mode, the wander amount ranges between 0
and the full randomizer amount.
9