Removing The Concord Absorber With The Three-Point Safety Belt - CONCORD ABSORBER XT Manual

CaUTiOn
!
• The lap and diagonal seat belt must
be lying flat and fully tensioned along
the base of the CONCORD ABSORBER.
• The seat belts must not be twisted.
• The shoulder strap must be run through
the shoulder harness guide, the harness
clip and the belt tensioner and must be
fully tightened.
• The harness clip must be engaged and
closed tightly.
• The support leg must rest securely on
the floor and must be locked in place.
Check the correct position of the seat belts before each use.
Please contact CONCORD directly if you have problems mounting the seat.
The seat belts must run through the belt guides marked in red on the seat.
The seat belt must not be laid out in any other way.
30
_ REMOVinG THE COnCORD aBSORBER WiTH
THE THREE-POinT SaFETY BElT
Press the size adjustment control (12)
upwards and move the headrest of the
CONCORD ABSORBER into its top-most
position.
Press and hold the seat tilt control (07)
upwards and move the seat part into its
front-most position.
Remove the shoulder strap from the
shoulder harness guide (13).
Push the support leg (11) into its
top-most position while keeping
the button for unlocking the
support leg (10) pressed.
Open the harness lock of the
5-point harness system and fold
the cover of the belt tensioner (06)
upward. Push the locker button
on the belt tensioner upwards
and open the belt tensioner (06)
completely.
Open the harness clip for the shoulder belt (14) on the
side by pressing the control button on the harness clip
(04).
Open the belt lock of the lap and diagonal seat belt,
and pull it out between the seat part and the base of
the CONCORD ABSORBER.
31