CONCORD ABSORBER XT Manual page 7

Open the harness lock of the 5-point
harness system and fold the cover of the
belt tensioner (06) upwards.
Push the locker button on the belt
tensioner upwards and open the belt
tensioner (06) completely.
Open the harness clip for the shoulder belt (14) on the
side of the lap and diagonal belt by pressing the control
button on the harness clip (04).
Run the lap and diagonal seat belt between
the seat part and the base of the CONCORD
ABSORBER and close the lock of the
three-point-harness.
28
The shoulder belt must run inside
the harness clip (14) and above the
latch pin of the belt tensioner (06).
The lap strap must run on the lap strap guides marked
in red and below the latch pin of the belt tensioner (06).
The seat belt must not be laid out in any other way.
The seat belts must not be twisted!
Pull the lap and diagonal belt until
it lies flat and close the harness clip
(14) carefully.
Now close the belt tensioner
and tighten the seat belt as
much as possible.
Close the cover of the belt tensioner.
Hook the seat belt into the shoulder
harness guide (13).
Press the button (10) to unlock the
support leg, and move the support leg (11)
downwards, until it rests securely on the
floor and you can hear and feel it lock into
position!
29