Advertisement
Quick Links
Installation Time: 15 minutes
Tools Required:
✓ T40 Torx Socket
✓ Ratchet
This guide is for installing the Rugged Ridge Mirror Relocation Brackets (J103353) on a 2007-2017 Jeep
Wrangler. Read all instructions carefully before starting. The images show both a T40 socket/ratchet and a T40
T-Handle driver – only the ratchet is necessary for the installation.
Before
After
Rugged Ridge Mirror Relocation Brackets
Manufacturer Part Number 11025.07
Model Number J103353
✓ Universal joint adaptor for ratchet
✓ Hammer
Advertisement
Related Manuals for Rugged Ridge J103353
Summary of Contents for Rugged Ridge J103353
- Page 1 ✓ Ratchet ✓ Hammer This guide is for installing the Rugged Ridge Mirror Relocation Brackets (J103353) on a 2007-2017 Jeep Wrangler. Read all instructions carefully before starting. The images show both a T40 socket/ratchet and a T40 T-Handle driver – only the ratchet is necessary for the installation.
- Page 2 Installation Instructions: 1. Park the vehicle on a level surface and apply the parking brake. 2. Using the T40 Torx and Ratchet (or T-Handle driver as shown), remove the bottom two bolts in the A- pillar cover plate that covers the windshield hinge. Retain the bolts for reinstallation. 3.
- Page 3 5. Moving to the factory door (in the images, it was removed from the vehicle, but that is not necessary), remove the two mirror mounting bolts on the inside of the door using the T40 torx socket and ratchet. Retain the bolts. 6.
- Page 4 7. Clean the surface of the door and install the door cover plate included with the relocation brackets by sliding it into the holes in the door. The longer mount on the back of the plate should be toward the bottom of the door.
- Page 5 9. Using the T40 Torx socket and ratchet, remove the bolt from the bottom of the mirror. These bolts are VERY tight and if there is any corrosion they may be difficult to remove. Starting it while the mirror is still on the door may help, but that would add risk of damaging the door.
- Page 6 10. Separate the lower mirror bracket from the mirror head. The mirror head is pressed into the base, you may have to partially reinstall the bolt and tap it with a hammer to get them to separate. You may notice that the mirror in this picture is new –...
- Page 7 12. Using the bolt from step 9 and the T40 Torx socket and ratchet, attach the mirror head to the relocation bracket. Tighten the bolt to 15 ft-lbs. 13. Test the ability to fold in the mirror. If the mounting bolt turns with the mirror, tighten the bolt more. Repeat until you can fold the mirror in without the mounting bolt turning with the mirror.
- Page 8 14. Adjust the mirror for proper visibility. 15. If using both relocation brackets, repeat the process on the other side. 16. Your installation is complete. Installation Instructions Written by ExtremeTerrain Customer 10872426 5/3/2017...
Need help?
Do you have a question about the J103353 and is the answer not in the manual?
Questions and answers