PowerTec UT1006 Instruction Sheet

INSTRUCTION SHEET
ADJUSTABLE ROUTER TABLE STAND
QUESTION...
1•847•780•6120
THINGS TO KNOW
• footprint/top – 20-9/16" x 28-7/16"
• height range with adjustable feet – 30-3/16" – 34-3/8"
• height range with levelers – 31-1/8" – 36-3/8"
• a shelf can be added to the lower tie bars
• mounting holes are located in the legs for
remote switch assembly
• for mobility, the included levelers can be removed and
casters (17201, not included) can be added
CAUTION
Do not modify or use this stand for any application other
than that for which it was designed.
CAUTION
Load Capacity Limit: DO NOT exceed maximum load
rating of 400 lbs. [181 kg.]. If casters have been installed,
do not exceed 400 lbs. [181 kg.] or the load rating of the
casters, whichever is less.
PACKAGING CONTENTS
ITEM DESCRIPTION
A Legs (29-1/2" x 1-15/16" x 1-15/16")
B Long tie bars
(27-3/8" x 2-3/4" x 3/4")
C Short tie bars (19-1/2 x 2-3/4" x 3/4")
D Adjustable feet
E Levelers (each leverer has two
flange nuts and two washers)
F 5/16"-18 x 5/8" carriage bolts
G 5/16" lock washers
H 5/16"-18 nuts
Figure 1
A
B
C
ASSEMBLY
1. Use eight 5/16"-18 x 5/8" carriage bolts (F), eight 5/16" lock
washers (G) and eight 5/16"-18 nuts (H) to assemble two
legs (A) and two long tie bars (B). Make sure the rails on the
bars are to the inside of the legs. FINGER TIGHTEN ONLY.
Assemble the other two legs (A) and two long tie bars (B).
2. Attach the two leg/long tie bar assemblies to the short tie
bars using sixteen 5/16"-18 x 5/8" carriage bolts (F), sixteen
5/16" lock washers (G) and sixteen 5/16"-18 nuts (H).
FINGER TIGHTEN ONLY.
Figure 2
QTY
4
4
A
4
4
4
48
48
48
D
Model No. UT1006
D
B
Orient Legs as Shown
C
E
F
G
H
E
F