curt 13432 Manual

13432
3/18/2008
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
Parts List
ITEM QTY PART NUMBER
1 4 1_2 - 13 x 4 1_2 HEX HEX BOLT
2 4 FW12 FW, 12, ZP
3 4 HFN 1213 HEX FLANGE NUT
HITCH WEIGHT: 15 LBS.
20
INSTALL TIME: MINUTES
INSTALL NOTES:
-NO DRILLING REQUIRED
-LOWER EXHAUST
INSTALLATION STEPS
1) Remove three bolts that are securing the existing tow hook to the bumper beam. Detach the muffler
from the rubber muffler hanger and lower the exhaust for ease of installation.
2) Position the hitch over the bumper beam and align the holes of the hitch with holes in the cross member.
When the hitch is properly positioned, the hitch will be centered in the existing rectangular cutout at the
bottom of the bumper fascia.
3) Insert fasteners as shown making sure the flange nuts are installed on the exterior side of the hitch.
4) Torque all 1/2" fasteners to 75 lb-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
JEEP WRANGLER 2-DOOR & 4-DOOR
DESCRIPTION
1
3500 LBS. TRAILER WEIGHT &
4000 LBS. TRAILER WEIGHT &
2
350 LBS. TONGUE WEIGHT.
400 LBS. TONGUE WEIGHT
BUMPER BEAM
EXISTING HOLES
IN BUMPER BEAM
3