curt 13422 Manual

13422 / RRH13422
8/31/2010
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
ITEM QTY PART NUMBER
1 2 CM-SP1
2 2 HFN 1213
3 4 M14-2 x 40mm LG.
4 4 9/16" CONICAL WASHER
5 2 1/2-13 x 1 3/4
NOTE: FASTENERS TYPICAL BOTH SIDES
5
1
2
HITCH WEIGHT: 32 LBS.
INSTALL TIME: 30 MINUTES
INSTALL NOTES:
NO DRILLING REQ.
INSTALLATION STEPS
1) Remove existing M14 bumper bracket bolts from the bottom surface of frame
and return to vehicle owner. (Both sides)
2) Raise hitch into position and install fasteners as shown.
3) Torque all 1/2" fasteners to 75 lb.-ft. Torque all M14 fasteners to 148 lb.-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
03-06 CADILLAC ESCALADE, SUBURBAN, YUKON, TAHOE
03-06 CHEVY AVALANCHE
Parts List
DESCRIPTION
.250 x 1.50 x 2.00" SQUARE HOLE SPACER
HEX FLANGE NUT
HEX BOLT
CONICAL TOOTHED WASHER
CARRIAGE BOLT
DRIVER SIDE FRAME RAIL
EXISTING WELDNUTS
INSIDE BUMER
4
3
EXCLUDES MODELS WITH CANISTER ON PASSENGER SIDE FRAME RAIL
6,000 LBS. TRAILER WEIGHT &
10,000 LBS. TRAILER WEIGHT &
PASSENGER SIDE FRAME RAIL
600 LBS. TONGUE WEIGHT.
1,000 LBS. TONGUE WEIGHT
EXISTING WELDNUT