Tuner Mode - DigiTech RP200 User Manual

Tuner Mode

The Tuner in the RP200 allows you to quickly tune or check the tuning on your guitar. Enter
Tuner mode by pressing and holding both Footswitches simultaneously.The Display will briefly
show TUNER indicating that you are in Tuner mode. To begin tuning, play a note on your guitar
(a harmonic at the 12th fret usually works best).The Display shows the note being played.The
Matrix LEDs indicate whether you are sharp or flat.The top 4 Red LEDs indicate the note is
sharp and should be tuned down.The bottom 4 Red LEDs indicate the note is flat and should be
tuned up.The center Green LED indicates the note is in tune. The output is muted in Tuner
mode.The Expression Pedal will unmute the output allowing signal to be heard while tuning. Exit
tuner mode by pressing either Footswitch.
In Tuner mode, you can change your tuning reference.The default factory setting is A=440 Hz.
(displayed as A=440). Rotating the Parameter 1 knob will select alternate dropped tunings.
Alternate tunings are A = Ab (displayed as A=A&), A = G (displayed as A=G), and A = Gb
(displayed as A=G&).The display window will briefly flash the currently selected tuning
preference.
10