Applying Power - DigiTech RP200 User Manual

Applying Power

Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to
a flat EQ response (on most amps, this would be 0 or 5 on the tone controls).Then follow the
steps listed below.
1.Turn the amp volume all the way down.
2. Connect the plug of the PS0913B power supply to the power jack on the rear panel of the
RP200.
3. Connect the other end of the PS0913B power supply to an AC outlet.
4.Turn the power of your amplifier(s) to the on position and adjust the volume(s)to a normal
playing level.
5. Gradually increase the RP200's Master Level to achieve the desired volume.
8