Detune; Pitch Shift; Whammy - DigiTech RP200 User Manual

Modeling guitar processor
Hide thumbs Also See for RP200:
Table of Contents

Advertisement

Detune (DetUNe)
A Detuner will make a copy of your incoming signal, take the copied signal slightly out of tune
from the original, and mix the two signals together.The result is a doubling type of effect as if
two guitars were playing the same part together.
Amount - The Parameter 2 knob adjusts the amount of pitch difference applied to the copied
signal. Ranges from -12 to 12.
Level - The Parameter 3 knob controls the mix of the detuned note. Ranges from 0 to 99.
Pitch Shift (PitCH)
A Pitch Shifter copies the incoming signal, then shifts the pitch of the copy to a different note.
The shifted note is then mixed back with the original signal sounding as if two guitars were
playing different notes.
Amount - The Parameter 2 knob selects the interval of the shifted pitch. Ranges from -12
(12 semitones below) to 24 (24 semitones above).
Level - The Parameter 3 knob controls the mix level of the shifted pitch. Ranges from 0 to
99.
Whammy™ (wHammy)
Whammy™ is an effect that uses an Expression Pedal to bend the pitch of the
incoming signal, or add a bendable harmony with the original signal. As the Pedal
is moved, the note will bend either up or down.When Whammy™ is selected, it is
automatically placed before the Amp Modeling as shown in the block diagram.
Amount - The Parameter 2 knob selects the interval and direction of the pitch bend. Choices
are as follow:
24

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents