DigiTech Artist GSP-2101 Owner's Manual page 39

Section 3 - Editing Effects
Attack Time: Controls how fast the gate opens after detecting a signal above THRESH-
OLD. Large numbers yield slower attack times, while small numbers give a fast attack.
Varies from 0 to 2000 milliseconds (2 seconds).
Release Time: Controls how fast the gate closes after the signal has fallen below HYS-
TERESIS for the amount of time set by HOLD TIME. Large numbers yield slow release
times, while small numbers give a fast release. Varies from 0 to 2000 milliseconds (2 sec-
onds).
Attenuation: Sets the amount of attenuation (signal reduction) when the gate is closed.
Varies from 100 dB (below the level of the nongated noise floor) to 0 dB (no attenua-
tion).
Delay Time: Acts as a pre-trigger for Program material. The source signal is detected,
but the gate is not opened until the time set by DELAY TIME has elapsed, after which,
the gate is then opened. This Parameter allows source material with very fast attack time
to be heard in its entirety, without the lag in gate response or attack transient loss that is
common to inferior noise gates. Variable from 0 to 10 milliseconds.
GSP-2101 Artist Owner's Manual 37