DigiTech Artist GSP-2101 Owner's Manual page 42

Section 3 - Editing Effects
LFO Waveform Type: Controls the LFO waveform pattern of the phasing effect. SINE
produces a smooth sine wave-type phasing with even transitions in and out of the turn-
around points. TRINGL is a linear phasing effect, and ramps the pitch of the wave up
and down with no slowing at turnaround points. LOG and EXPN waveforms offer a
more intense sound characteristic unique to the GSP-2101 Artist.
Wahs
Effect On / Off: Turns the Module on or off. When the Module is turned off, its
Parameters are not displayed, but signal will continue to pass through the module. To
see the Parameters, you must turn the Module on.
Level: Controls the overall level of the wah effect. Varies from 0 to 100.
Sensitivity: Adjusts the sensitivity of the detection for the automatic wah. High SENSI-
TIVITY settings cause the wah filter to open wider. Low settings limit the wah filter
range. Varies from 0 to 100. This Parameter appears only in the automatic wah Module.
Pedal Position: The PEDAL POSITION Parameter reflects the current setting of the
continuous control device used to control the wah effect. This Parameter can be modi-
fied manually using the Data wheel or by using a continuous control device (such as the
optional DigiTech Control One) to perform the wah function. As the Parameter is
modified, the tone of the original note will change, exactly like using a stand-alone wah
pedal. Ranges from 0 to 100.
Duckers
Effect On / Off: Turns the Module on or off. When the Module is turned off, its
Parameters are not displayed but, signal will continue to pass through the module. To
see the Parameters, you must turn the Module on.
Control Threshold: Sets the minimum input level required to trigger the ducker (this
Parameter can be thought of as the ducker sensitivity). Higher settings of CONTROL
THRESHOLD require higher input levels to trigger the ducker. Lower settings make the
ducking effect easier to trigger. Ranges in 1 dB step from -100 to 0 dB.
Hold Time: Controls the amount of time before the ducker disengages after the signal has
stopped. Varies from 0.000 to 5.000 seconds.
Attenuation: Adjusts the amount of level attenuation applied to the ducked effects
when the ducker is engaged (ducker is engaged when the input level exceeds the setting
of CONTROL THRESHOLD). Adjustable from -100 dB to 0 dB.
Attack Rate: Sets the amount of time over which the ducker will reach full attenuation.
Adjustable in milliseconds from 0.00 to 14.00 seconds.
Release Rate: Sets the amount of time over which the ducker will disengage. Adjustable
in milliseconds from 0.00 to 14.00 seconds.
40 GSP-2101 Artist Owner's Manual