Table of Contents
Advertisement
Section 3 - Editing Effects
RV Diffusion: RV DIFFUSION controls the smoothness of the reverberation. In a real
room, reverberation is naturally diffused by the air. However, diffusion can also be
affected by temperature, humidity, and the presence of absorptive or reflective materials
in the reverberant space. Ranges from 1 to 10.
RV Hi-Freq Decay: Controls the decay length (damping) of the high frequency rever-
berations. Variable from 25Hz to 20 kHz.
RV Hi-Frq Rolloff: This is a low-pass filter that sets the rolloff frequency of the reverber-
ations and early reflections. This is a band-limiting control, and the frequencies above
the setting of this Parameter will be rolled off rapidly. Variable from 25Hz to 20 kHz.
RV Room Size: Sets the apparent size of the reverberant space. As the setting of RV
ROOM SIZE is increased or decreased, the settings of both RV RTMID and RV
RTBASS change to correspond with the new room size setting (the settings of RV
RTMID and RV RTBASS retain the same relative settings when RV SIZE is modified).
Changing the setting of either RV RTMID or RV RTBASS does not affect the setting
of RV ROOM SIZE, however. Ranges from 1 to 10.
RV RTMid: Controls the length (RT60) of the midrange reverb frequencies after the
signal has stopped. Remember that after the reverberations have decayed 60 dB in the
presence of continuous program material, they are no longer audible to the listener.
Ranges from .01 to 20 seconds.
RV RTBass: Controls the RT60 of the low frequency reverberations after the signal has
stopped. Ranges from .01 to 20 seconds.
RV RT60: Controls the length of the reverberation after the signal has stopped. Ranges
from .01 to 20 seconds.
PEQ Frequency: Sets the reverb equalization frequency. Varies from 25 Hz to 20 kHz.
PEQ Q (Bandwidth): Adjusts the narrowness of the equalization filter. Variable from .25
to 16.00. For more about Q, see the section on equalizer Modules, pg. 20.
PEQ Gain: Controls the amount of boost or cut at the frequency specified by the setting
of PEQ FREQUENCY. Ranges from -15 dB to +15 dB.
RV Mid Level: Sets the overall level of the midrange reverberations. Varies from 0 to
100.
RV Bass Level: Sets the overall level of the low-frequency reverberations. Varies from 0
to 100.
RV Stereo Blend: Appearing only in stereo reverb Modules, RV STEREO BLEND con-
trols the amount of reverberation reflections from the left side of the stereo image to be
mixed into the right channel, and vice versa. When set at 0, the stereo image of the
reverberation is completely preserved, with no mixing of reverberations from opposite
channels. As this Parameter is increased, the stereo image becomes less apparent, until
at a setting of 100, the reverberations from both the left and right can be heard in
either channel.
RV Level: Controls the overall level of the reverberations. This control also acts as the
master level for stereo setups. Varies from 0 to 100.
GSP-2101 Artist Owner's Manual
25
Advertisement
Table of Contents
