Stereo Record - DigiTech GNX3 User Manual

Recorder
GTR DRY
– Select this input to route a dry, unprocessed guitar signal direct from the input to the
recorder while processed signal is heard at the GNX3's outputs. This input is great for laying down a dry
guitar track that can be replayed through different amp models and presets using the Reamp input . You
can still monitor the guitar signal through all of the GNX3's effects processing while recording.
GTR AMP
– Select this input to tap the guitar signal right after the Noise Gate, and send it to the
recorder, while a processed signal is heard at the GNX3's outputs. This mode is great for laying down a
dry guitar amp track without modulation, delay, or reverb effects but still monitoring these effects out the
GNX3's outputs while recording.
REAMP 1-8
– Select one of these inputs to route the selected track back through the current GNX3's
preset. This is great for guitar tracks that were recorded using
experiment by playing these tracks back through different amp models, effects, or entirely new presets.
This is exactly how professional recording engineers mix down guitar tracks. To select the input
configuration for recording, follow these steps:
1. Begin with the recorder stopped.
2. Press the SETUP button once. The GNX3's main display reads
selected input configuration. Default from the factory is guitar.
3. Use the DATA WHEEL to select one of the 10 different input configurations you want to use for
recording.
4.When finished, press EXIT.
NOTE: When the STOP button is pressed after using the
recording, the input configuration will automatically be reset to

Stereo Record

The recorder can be setup to automatically arm pairs of tracks for recording in stereo. When Stereo
Record enabled, each time you press the RECORD button or footswitch, the recorder will automatically
arm a pair of tracks to record to. Each track is automatically panned hard left and hard right respectively
to maintain a stereo image. Track 1 is paired with track 2, track 3 is paired with track 4, and so on. To
use Stereo Record, follow these steps:
40
GTR DRY GTR AMP
or
recinput
. The display flashes the
reamp
input configuration for
guitar
because you can
.