Connection & Record Sequence; Using Jamsync - DigiTech JamMan Express XT Owner's Manual

Using JamSync

Connection & Record Sequence
JamSync allows you to synchronize multiple JamSync compatible devices using optional 1/8"
mini stereo (TRS) cables (see below cable diagram)� This allows a JamSync master to control
the loop playback and stop functions for all connected JamSync slaves, providing multi-track
looping capabilities� You can cascade multiple JamMan Express XTs for single-player/multi-
track looping or collaborate with other musicians, each recording and cueing their own
loops for expressive multi-player/multi-track looping�
Tip
Sleeve
(Ground)
Ring
OUT
MASTER
Record First
JamSync
Optional
There are two methods for recording loops to a JamSync slaved JamMan device:
• Manual Slave Recording Method
Using this method, you can record to the master then wait until you're ready to
record to the slave� This method works well if you do not wish to immediately
8
1/8" Stereo Cable (TRS)
1/8" Mini Stereo (TRS) Cable Diagram
JamSync
IN OUT To Next JamSync Slave
.
SLAVE
Record Second
Tip
Sleeve (Ground)
Ring
To use JamSync, connect the master device's
JAMSYNC OUT
of the first slave device� The
LEDs on the slaved device will briefly flash,
indicating the unit is in slave mode� Daisy chain
any remaining slaves in the same manner�
When cascading multiple JamMan Express XTs
in series and using JamSync, the last JamMan
Express XT device in the chain should be the
master� You will then want to record to the
last JamMan Expess XT device in the signal
chain (the master) first, then the second to
last device, etc�, working your way backwards
through the signal chain� Performing these
actions will ensure you record only what you
intend to during each pass�
Sleeve
(Ground)
Ring
jack to the
JAMSYNC IN
and
REC
Tip
jack
PLAY