SecurityMan SECURITYBARS User Manual

SECURITYBARS User Manual
Adjustable Door and Window Security Bar Alarm
Safety precautions:
When using this product, the safety precautions below must be taken to avoid legal liabilities and damages. Retain and follow all product safety and operating instruc-
tions. Observe all warnings in the product operating instructions. To reduce the risk of bodily injury and damage to the equipment, observe the following precautions.
• Always use door and window locks in conjunction with the security bar alarm.
• Always make sure that the caps at the end of the bar are pushed in tightly.
• Do not modify the security bar. Improper modifications can cause it to be inoperable and or cause damages to peripheral equipment.
• Never place the rubber foot of the SECURITYBARS on loose rugs or mats.
Contents:
top
middle
bottom
SECURITY BARS
Setup & Installation
The security bar can be used on both hinged and/or sliding doors and windows. The following guide will show you how to place the security bar on both applications.
ASSEMBLING THE BAR
Line up the bars as shown in the image below. Then simply push in the gold plated push buttons and slide the bars into each other. Once fully assembled you can adjust
the length of the bars by pressing in the middle bars push button and sliding it lower into the bottom bar as needed.
(Top bar)
ATTACHING THE ALARM
1. Remove the battery compartment cover and connect the 9V battery to the battery cable. Once connected, insert the battery into the battery compartment and re-attach battery cover.
2. Slide the alarm over the top bar (button side facing up towards the open end of the top bar).
3. Tighten the alarm into place.
1
-
+
TM
(fork/top) (foot/bottom) (smaller
on top)
DOOR CAPS SLIDINGDOOR
WINDOW CAPS
2
(larger
on bottom)
ALARM
(Middle bar)
-
+
ALARM 9V BATTERY USER'S MANUAL
SCREWS
(Bottom bar)
3
USER'S
MANUAL