SecurityMan SECURITYBARA User Manual

SECURITYBARA User Manual
Adjustable Door and Window Security Bar Alarm
Introduction:
The SecurityMan SECURITYBARA ™ is a heavy duty; dual function security bar made from high grade iron that can secure just about any hinged doors, sliding doors,
and/or windows. The SECURITYBARA ™ also comes with a 120dB "vibration activated" alarm for added security and is fully adjustable with an angled rubber bottom
that assures full contact and strong grip on all types of floors without scratching them.
Features:
• Fully adjustable to ensure full floor and window contact
• Made of high grade iron for added strength
• Compatible with most hinged doors or sliding doors/windows
Important
This guide provides important information on the use and operation of your SECURITYBARA and the images/features shown throughout the manual are subject to
change without notice. Please read all the information carefully prior to using the product for the best performance and to prevent any damage/injuries or misuse of
the device(s). Customers are entitled to have read through this complete user's manual before using the SECURITYBARA. Any unapproved changes or modifications
will void your warranty. Please ensure to have a complete understanding of the following restrictions.
Restrictions:
When using this product, the safety precautions below must be taken to avoid legal liabilities and damages. Retain and follow all product safety and operating instruc-
tions. Observe all warnings in the product operating instructions. To reduce the risk of bodily injury and damage to the equipment, observe the following precautions.
• Always use door and window locks in conjunction with the security bar alarm.
• Always make sure that the caps at the end of the bar are pushed in tightly.
• Do not modify the security bar. Improper modifications can cause it to be inoperable and or cause damages to peripheral equipment.
• Never place the rubber foot of the SECURITYBARA on loose rugs or mats.
Contents:
Setup & Installation
The SECURITYBARA can be used on both hinged and/or sliding doors and windows. The following guide will show you how to place the SECURITYBARA on both
applications.
ATTACHING THE ALARM
1. Remove the battery compartment cover and connect the 9V battery to the battery cable. Once connected, insert the battery into the battery compartment and re-attach battery cover.
2. Grab the thinner of the 2 tubes and slide the alarm over the opposite side of the push-button end (On/Off buttons facing upward) of the tube. Then tighten the alarm into place.
TM
1
• Interchangeable caps for hinged door and sliding door/window usage
• 120dB vibration activated alarm for added security
• Up to one year battery life (1x 9Volt included)
2