SecurityMan SECURITYBAR User Manual

SECURITYBAR User Manual
Adjustable Door and Window Security Bar
Introduction:
The SecurityMan SECURITYBAR is a heavy duty; dual function security bar made from high grade iron that can secure just about any hinged and/or sliding doors and
windows. The SECURITYBAR is fully adjustable with an angled rubber bottom that assures full contact and strong grip on all types of floors without scratching them.
Features:
• Extra security for door and window
• Adjustable to fit most doors and windows
• Simple to use
• Rugged heavy duty iron
Important
This guide provides important information on the use and operation of your SECURITYBAR and the images/features shown throughout the manual are subject to
change without notice due to system and firmware upgrades. Please read all the information carefully prior to using the product for the best performance and to
prevent any damage/injuries or misuse of the device(s). Customers are entitled to have read through this complete user's manual before using the SECURITYBAR. Any
unapproved changes or modifications will void your warranty. Please ensure to have a complete understanding of the following restrictions.
Restrictions:
When using this product, the safety precautions below must be taken to avoid legal liabilities and damages. Retain and follow all product safety and operating instruc-
tions. Observe all warnings in the product operating instructions. To reduce the risk of bodily injury and damage to the equipment, observe the following precautions.
• Always use door and window locks in conjunction with the security bar.
• Always make sure that the caps at the end of the bar are pushed in tightly.
• Do not modify the security bar. Improper modifications can cause it to be inoperable and or cause damages to peripheral equipment.
• Never place the rubber foot of the SECURITYBAR on loose rugs or mats.
Contents:
Setup & Installation
The SECURITYBAR can be used on both hinged and/or sliding doors and windows. The following guide will show you how to place the SECURITYBAR on both applica-
tions.
SLIDING DOORS AND WINDOWS
1. Attach the white caps to the ends of the SECURITYBAR, and adjust the length of the bar by pressing in the gold button and slightly rotate either tube so that the
alignment holes and button are misaligned, then slide the smaller tube in or out to make your adjustments.
2. Once you've reached the desired length, rotate the tubes so that the button and holes are realigned and the button pops back out of the alignment hole.
3. Place the SECURITYBAR in-between the sliding door /window and the sliding door/window frame.
TM