EAST OAK EO-PH001 User Manual

Torch firecove patio heater 50000 btu

Hide thumbs Also See for EO-PH001:

Owner's manual (27 pages)

Owner's manual (15 pages)

Table Of Contents

Table of Contents

Quick Links

Download this manual

User Manual of Product 1:

EAST OAK 50,000 BTU Propane Patio Heaters with Round

Table Design, 304 Stainless Steel Burner, Triple Protection

System, Wheels, Outdoor Patio Heaters for Commercial and

Home, Blue

User Manual of Product 2:

EAST OAK Patio Heater Reflector Shield, Propane Patio

Heaters Focusing Reflector for Extra Heat Reflecting Power,

Enegy Saving, Heating Reflector for Directional Heating,

0.7mm Thickened Aluminum

Table of Contents

Need help?

Do you have a question about the EO-PH001 and is the answer not in the manual?

Questions and answers

Summary of Contents for EAST OAK EO-PH001

Page 1 User Manual of Product 1: EAST OAK 50,000 BTU Propane Patio Heaters with Round Table Design, 304 Stainless Steel Burner, Triple Protection System, Wheels, Outdoor Patio Heaters for Commercial and Home, Blue User Manual of Product 2: EAST OAK Patio Heater Reflector Shield, Propane Patio...
Page 2 TORCH Firecove Patio Heater 50000 BTU Owner’s Manual MODEL: EO-PH001 EO-PH22002 EO-PH22003 EO-PH22004...
Page 4 eastoak.com Question? Comments? Reach out to us to get expert support! support@eastoak.com eastoak.com 1-833-EAST-OAK (USA) (1-833-327-8625) Follow eastoakliving on Claim 3-year warranty at eastoak.com/warranty EASTOAK.COM PATIO HEATER...
Page 5: Important Caution
IMPORTANT CAUTION Please verify all parts and components present and check for any damaged pieces before assembly. If you have any damaged or missing parts, please contact customer service at support@eastoak.com. • Some parts may contain sharp edges and may cause injury or property damage.
Page 6: Safety Guide
WARNING • Do not store or use any gasoline or other flammable vapors or liquids close to this appliance. All propane tanks not connected to the heater should be stored at a separate location. • Improper installation, alteration, service, or maintenance may cause property damage, injury, or death.
Page 7 SAFETY GUIDE • Do not attempt to use fire to check for gas leaks. • Max. supply pressure is 11 WC. • Recommended propane gas tank size is as follows – diameter: 12”, height: 18”, weight: 20 lbs. • You must use a propane tank that has a collar to protect the gas valve. •...
Page 8 • Do not operate on a boat or vehicle. This unit must be used on a flat surface and outdoors ONLY. • Always remove protective cover before operating (if applicable). • Check for leaks after not using the unit for long periods of time. •...
Page 9 SAFETY GUIDE • Be mindful to not block the flow of combustion and ventilated air. Proper ventilation allows for the appliance to burn effectively. • Make sure the ventilation openings are free of debris. • Visually checking burner flames, with pictorial representations. •...
Page 10: Care And Maintenance
CARE AND MAINTENANCE • Before any maintenance, always disconnect the propane gas tank. • Ensure the heater is free from any debris or combustible materials. • Use a soft brush to clean any mild stains, loose dirt, or soil only after the heater has completely cooled down.
Page 11: Parts Diagram
PARTS DIAGRAM 1-833-327-8625 SUPPORT@EASTOAK.COM...
Page 12: Parts List
PARTS LIST M8 Flange Nut Bolt M8x16 (packed with part I) (2 pcs packed with part I) (X2) (X3) *spare part X1 M6 Flange Nut Stainless Steel Bolt (X4) (X6) *spare part X1 *spare part X1 Bolt M6x30 Reflector Spacer (X3) (X6) *spare part X1...
Page 13 PARTS LIST Washer Post Bolt (X9) (X4) *spare part X1 *spare part X1 Screw M6x8 Cap Nut (X12) (X12) *spare part X1 *spare part X1 Wing Nut Wrench (X3) (X1) *spare part X1 1-833-327-8625 SUPPORT@EASTOAK.COM...
Page 14 Anchoring Arm Bolt M6x10 (X3) (X6) *spare part X1 M6 Nut (X6) *spare part X1 Before assembly, check and confirm all parts are present. Compare parts present with the content lists, including all hardware. If any parts or hardware pieces are missing or damaged, please contact customer service at support@eastoak.com.
Page 15 ASSEMBLY INSTRUCTIONS Flip the base upside down with the hollow side facing up. Attach the wheel assembly (I) to base (H) using 2 M8 flange nuts (AA) and 2 M8x16 bolts (BB). Then, AA (X2) BB (X2) connect the arm (MM) to the base (H) with 6 M6 nuts (OO) and 6 M6x10 bolts (NN).
Page 16 Attach lower post (F) to support brackets (G) using 6 pcs bolts M6x30 (EE) and 6pcs M6 flange nuts (CC). Secure bolts tightly. CC (X6) EE (X6) Place the tank housing on top of the post and slide the tank housing down towards the base. EASTOAK.COM PATIO HEATER...
Page 17 Insert the regulator (J) from the top end of the upper post (E), then attach the burner assembly (C) to upper post (E) using the 4 bolts (DD). DD (X4) Secure bolts tightly. Insert the regulator (J) from the top end of the lower post (F).
Page 18 WARNING: Remove protective covers before assembly. Note: If needed, loosen each screw prior to further assembly. II (X12) JJ (X12) Re-tighten screws once all sections are aligned. Attach 6 pcs reflector panels (A) to center reflector (B) using 12 pcs Screws M6x10 (II) and 12 pcs cap nuts (JJ). Fully tighten all of the screws.
Page 19 Attach 3 pcs reflector spacers (FF) and 3 pcs washers (GG) to burner assembly (C) firstly. Tighten the reflector spacers. Slide 3 pcs washers (GG) over threaded end of spacer. FF (X3) GG (X9) Attach the reflector assembly to the top of reflector spacer (FF) using 3 pcs washers (GG) and 3 pcs wing nuts (KK).
Page 20 Turn the cylinder valve on the tank clockwise to close the propane tank. Attach the regulator (J) to the cylinder valve by turning the regulator coupling nut clockwise. Make sure it is fastened securely and tighten connections by hand only. PRESSURE RELIEFVALVE CYLINDERVALVE...
Page 21: Operation
OPERATION • Before performing a leak test, ensure that there are no open flames or flammable items nearby. Only move forward with the leak test in an open, spacious, outdoor area. Connect the propane tank to the regulator and turn the valve to the “OFF” position. Clean all connections with mild soap and water.
Page 22: To Turn The Heater Off
• When lit for the first time the heater may emit a slight odor and smoke. This is a normal and temporary condition. Emitter screen will become a bright red due to the heat. The color is more visible at night. Flame patterns should be a blue flame;...
Page 23: Troubleshooting
TROUBLESHOOTING Problem Cause Solution The burner will not light. The burner injector is clogged. Clean the burner injector. There is low gas supply pressure.C all your gas supplier. The bur There is low gas pressure.C all your gas supplier. immediately after ignition. The ignition is delayed.
Page 24: Warranty And Service
WARRANTY AND SERVICE GUARANTEED 3-YEAR WARRANTY Thank you for choosing East Oak. This product is covered by our company warranty for up to 3 years from its original purchase date. CLAIM WARRANTY If you’d like to claim your product’s warranty, register your new product on our website at www.eastoak.com/warranty.
Page 25 Torch Firecove Patio Heater Series 1-833-327-8625 SUPPORT@EASTOAK.COM...
Page 27 support@eastoak.com eastoak.com 1-833-EAST-OAK (USA)
Page 28 Heat Focusing Reflector for Patio Heater Instruction CAUTION:THE REFLECTOR MUST BU ASSEMBLED ON THE OPPOSITE SIDE OF THE CONTROL KNOB. Parts list Right Panel x1 Bracket x3 Fix screws x3 Left Panel x1 Protect cover x3 M6 screws x 6 M6 Cap nuts x6 Middle Panel x1 M6 screws x 6...

This manual is also suitable for:

Eo-ph22002 Eo-ph22003 Eo-ph22004

EAST OAK EO-PH001 User Manual

Quick Links

Need help?

Questions and answers

Related Manuals for EAST OAK EO-PH001

Summary of Contents for EAST OAK EO-PH001

This manual is also suitable for:

Table of Contents