1. Manuals
  2. Brands
  3. EAST OAK Manuals
  4. Patio Heater
  5. SB15BK2
  6. Owner's manual

EAST OAK SB15BK2 Owner's Manual

1500w 2-in-1 electric patio heater
Hide thumbs

Advertisement

Table of Contents

1500W 2-in-1
Electric Patio Heater
Owner's Manual
MODEL:
SB15BK2
EASTOAK.COM
OWNER'S MANUAL
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SB15BK2 and is the answer not in the manual?

Questions and answers

Related Manuals for EAST OAK SB15BK2

Summary of Contents for EAST OAK SB15BK2

  • Page 1 1500W 2-in-1 Electric Patio Heater Owner’s Manual MODEL: SB15BK2 EASTOAK.COM OWNER’S MANUAL...
  • Page 2 ( 9am-5pm PST/PDT ) installation video Unlock all the perks! Welcome to the East Oak family! Start the registration process now for a 3-year warranty. Stay updated with our latest news and exclusive discounts by following us on social media!

  • Page 3: General Safety Information

    IMPORTANT INFORMATION 8.Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended. 9. Do not use near or in the immediate vicinity of a bath or swimming pool or any source of liquid.
  • Page 4 25. To prevent overheating of this appliance, keep the air inlets and outlets clean and 8. The distance of your appliance from the living beings or materials such as wood, free of anything that may cause blockage. Check all inlets and outlets from time to carton, cloth etc.

  • Page 5: Function Instruction

    The commercial heating applications within indoor and outdoor areas. adapter should not be used if a three-slot grounded receptacle is available. SB15BK2 Model TIPS: The adapter needs to be purchased separately.
  • Page 6 GENERAL PARTS LIST TRIPOD MOUNTED PARTS LIST NOTE: • Please make sure all parts are there before beginning assembly. • If there is a missing piece, please contact after-sales. Plastic Curved Washer I-Shaped Bracket TMS Screw X 1 PC X 1 PC X 2 PCS Heater X 1 PC...
  • Page 7 TRIPOD MOUNTED ASSEMBLY INSTRUCTIONS With the help of a partner, attach the heater assembly to tripod stand using a PM6mm x 60mm machine screw (B) and a wing nut .(A). A X 1PC Fasten the I-shaped bracket (E) to the back of the heater using the pre-installed two wing nuts .
  • Page 8 Using the pre-installed two wing nuts and TMS screws If You Need To Install Floor Nails (G) to attach the protection grid to the heater. ATTENTION: Tilt protection grid must be installed G X 2PCS Adjust the foot cover to the appropriate height and then lock it on the before plug-in.
  • Page 9 Put the heater on the ground nail and lock the nut. WALL MOUNTED PARTS LIST NOTE: Please make sure all parts are there before beginning assembly. Ground PA5mm x 25mm L-Shaped Bracket Plastic Anchor Mounting Screw X 4 PCS X 4 PCS X 4 PCS Align the hole of the upper tube with the hole of the lower tube, then plug the pin in, and finally tighten the knob.
  • Page 10 WALL MOUNTED ASSEMBLY INSTRUCTIONS Drill holes for the plastic anchors using a 1/8 - 5/32 in. drill bit. Insert the point end of plastic anchor (I) into the holes. Tap the plastic anchor with a hammer until Fasten the 4 L-shaped brackets (H) by 2 pieces of M6mm x I X 4PCS the plastic anchor is flush.
  • Page 11 OPERATION INSTRUCTIONS Fasten the heater to the L-shaped bracket using the pre-installed wing bolts on the back of the heater and hand tighten the wing nuts. LED Display Power off Timer Hour Stand-by Error- over Heat Protection Power Level Step 1: Plug in the heater.
  • Page 12 Inserting Batteries (not included) TEMPERATURE FIELD Insert 2 AAA/ Alkaline type batteries into your remote control 1.Flip the backside of your remote control and pull out battery cover. Insert the batteries in accordance with the instructions and polarity the batteries. 2.Change the batteries in the same way depicted above.

  • Page 13: Top View

    TOP VIEW CARE AND MAINTENANCE Overheating Area Maintenance Warmer Area ( for freezing temperature ) Cozy Area ( for normal cold weathwer ) • Attention! Giving careful and regular maintenance to your heater according to our instructions is of utmost importance to ensure long and efficient operation of your Low Temperature Rise Area appliance.

  • Page 14: Warranty Policy

    • Storage: Store the heater in a cool, dry location when not in use to prevent dust Thank you for choosing East Oak. This product is covered by our company and dirt build-up. Wrap the power cord with ties. Use packaging cartons to store.
  • Page 15 support@eastoak.com eastoak.com 1-833-EAST-OAK (USA) PATIO HEATER...

Table of Contents