86-88 VOLKSWAGEN QUANTUM WAGON
11561
4/2/2010
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
Parts List
ITEM
QTY
PART NUMBER
DESCRIPTION
1
6
HFN3816
HEX FLANGE NUT
2
6
3/8 - 16 x 1 1/4
HEX BOLT
3
4
3/8"
FENDER WASHER
FLOOR PANEL
HITCH WEIGHT:
11
LBS.
INSTALL TIME
45
PROFESSIONAL:
MINUTES
90
NOVICE (DIY):
MINUTES
INSTALL NOTES:
- TEMP CLEAR TRUNK
- DRILLING REQUIRED
- SILICONE HARDWARE
- TRIM BUMPER FASCIA
INSTALLATION STEPS
1. Clear the trunk of all contents for drilling. Position the hitch against the floor panel and bumper centered and
square with the vehicle. Trim bumper fascia where the hitch bracket makes contact. The hitch must attach
directly to the metal bumper. Using the hitch as a template, mark and drill (4) places in the floor panel and
(2) places in the bottom of the bumper for 3/8" bolts.
2. Bolt the hitch to the trunk pan and bumper using fasteners as shown. Fender washers MUST be
installed at the floor panel OPPOSITE the hitch.
3. Torque all 3/8" fastener to 30 lb-ft.
4. Use silicone sealant around fasteners installed in the trunk to seal out water and exhaust fumes.
5. Reinstall trunk contents removed in step 1.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
217267
1,500
LBS. TRAILER WEIGHT &
1-800-798-0813
2
3
DRILL HOLES
BUMPER BEAM
150
LBS. TONGUE WEIGHT.
1
DRILL HOLES
Need help?
Do you have a question about the 11561 and is the answer not in the manual?
Questions and answers