curt 11521 Manual

11521 89-92 DODGE COLT / MITSUBISHI MIRAGE
10/26/2009
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
Parts List
ITEM QTY PART NUMBER
1 1 1/2-13 x 1 3/4 HEX BOLT
2 2 7/16-14 x 1 1/2 HEX BOLT
3 2 7/16 HELICAL LOCK WASHER
4 1 CM-SP24 .250 x 2.00 x 2.00" ROUND HOLE SPACER
5 1 HFN 1213 HEX FLANGE NUT
6 2 7_16-14 TAB NUT HANDLE NUT
7 1 CM-11521-SP .313 x 1.25 SPACER BLOCK
HITCH WEIGHT: 7 LBS.
INSTALL TIME
PROFESSIONAL: 45 MINUTES
90
NOVICE (DIY): MINUTES
INSTALL NOTES:
-DRILLING REQUIRED
-REMOVE LICENSE PLATE
-TRIM FASCIA
INSTALLATION STEPS
1. Remove the rear licence plate. Position the hitch on the car as shown. The hitch tab is placed to the right
(passenger) side of the vehicle tie down bracket. Temporarily fasten the hitch at the tie down using fasteners
as shown, and level the hitch in final position.
2. Mark the bumper fascia and cut away for spacer block to fit directly against the bumper beam.
3. Use the hitch holes to mark the bumper beam for mounting holes. Drill these holes for 7/16" diameter bolts.
4. Fasten the hitch at the bumper using fasteners as shown. Handle nuts are placed through existing access
holes in the forward side of the bumper beam OR by making additional holes in the fascia and bumper beam
under license plate, but to either side of the hitch bracket.
5. Torque all 1/2" fasteners to 75 lb-ft, and all 7/16" fasteners to 50 lb-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
217221
DESCRIPTION
6
BUMPER BEAM
1,000 LBS. TRAILER WEIGHT &
1-800-798-0813
1
5
4
100 LBS. TONGUE WEIGHT.
7
CUT AWAY FASCIA
FOR SPACER BLOCK
3
2