Moen Creative Specialties Iso DN0786 Installation Instructions

Iso™ Technical Specification
Towel Ring
Stock Numbers:
DN0786CH – Towel Ring

Chrome Finish
DN0786BN – Towel Ring

Brushed Nickel Finish
Materials:
Towel Ring post is constructed of
zinc. Ring is aluminum.
Dimensions:
Installation Instructions:
Directions below are for installation into dryw all. If installing product into a stud, use
the w ood screw s and w ashers provided only.
1.
Remove mounting posts from the product assemblies by loosening each setscrew.
Position the mounting plate on the wall at desired location with "UP" facing you. Mark hole
2.
locations.
Drill two holes as marked using a 5/16" drill bit.
3.
4.
Fold ends of the plastic toggle together and insert into each hole in the wall.
5.
Lightly tap anchors until flush with the wall.
6.
One at a time, insert plastic pin into each of the anchors and lightly tap to activate anchor.
Remove pin and repeat on the other anchor.
Place the mounting plate on the wall over the installed wall anchors with "UP" facing you.
7.
8.
Tighten screws.
9.
Place decorative product over the mounting plate with the setscrew facing down. Tighten
setscrew.
Cleaning Instructions:
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Stock Number:______________________Towel Ring
By Creative Specialties
2 5 3 0 0 A L MO E N D R I V E  N O R TH O L MS TE D , O H 4 4 0 7 0
C O R P O R A TE H E A D Q U A R TE R S : ( 8 0 0 ) 3 2 1 - 8 8 0 9  F A X: ( 8 0 0 ) 8 4 8 - 6 6 3 6
I N TE R N A TI O N A L : ( 4 4 0 ) 9 6 2 - 2 0 0 0  F A X: ( 4 4 0 ) 9 6 2 - 2 7 2 6
C U S TO ME R S E R V I C E ( U S A ) : 8 0 0 - 8 8 2 - 0 1 1 6  F A X: ( 8 8 8 ) 3 7 9 - 2 7 2 0
W W W . MO E N . C O M

Copyright Creative Specialties International
DN0786
Literature #BA1403