Moen INS232A Installation Instructions

1.
CAUTION: NOT TO
BE USED AS A
GRAB BAR.
3.
Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to the original consumer purchaser all
parts of this product to be free from defects in material and workmanship during normal use, for (1) year from date of purchase. A replacement for any defective
part will be supplied free of charge for installation by you. Defects or damage caused by the use of other than genuine Moen parts are not covered by this
warranty. This warranty shall be effective from the date of purchase as shown on the purchaser's receipt. Some states do not allow limitations on how long an
implied warranty lasts, so the above limitation may not apply to you.
This warranty is valid for the original purchaser only and excludes product damage due to installation error, product abuse, or product misuse, whether
performed by a contractor, service company, or yourself. Moen will not be responsible for labor charges, and/or damage incurred in installation, repair or
replacement, nor for incidental or consequential damages.
Some states, provinces, and nations do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions
may not apply to you. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state, province to province,
and nation to nation.
Moen Incorporated will advise you of the procedure to follow in making warranty claims. Simply write to Moen explaining the defect and include proof of
purchase and your name, address and telephone number. The address is: Moen Incorporated, 25300 Al Moen Drive, North Olmsted, OH 44070-8022, or call
our toll-free consumer Helpline: 1-800-289-6636.
In Canada, write to Moen Inc., 2816 Bristol Circle, Oakville, Ontario L6H5S7 or call: Toronto, 905-829-3400; Rest of Canada, 1-800-465-6130, and ask for
Product Service.
®
At the desired bar location, drill two
1/4" diameter holes in the wall, at
the spacing shown above (be sure
that holes are drilled perpendicular
to the floor line).
Attach back plate to the wall with screw provided. Insert
the bar into the bracket with the dimple in the bar facing
the wall. Attach bracket and bar to back plate. Insert
screw, then place cap over the screw hole.
LIMITED WARRANTY
25300 Al Moen Drive, North Olmsted, OH 44070-8022
HANDSHOWER SLIDEBAR ASSEMBLY
INSTALLATION INSTRUCTIONS
31-9/16"
2. Place the two plastic screw anchors
provided into the holes and gently
tap with a hammer until flush with
finished wall.
ONE YEAR
®
®
INS232A
WARNING
Removal of the flow control
o-ring from the flow
restrictor in the shower
wand between the wand
and the hose connection
could cause the wand to
separate from the hose as-
sembly under use and may
cause a safety hazard.
© Copyright, 1999
Moen Incorporated