curt 11103 Manual

11103
10/20/2010
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
Parts List
ITEM QTY PART NUMBER
1 2 M14 - 2 HEX NUT
2 2 M8 - 1.25 x 30 HEX BOLT
3 2 5/16"
4 2 1/4"
5 2 9/16
3
2
HITCH WEIGHT: 24 LBS.
INSTALL TIME
10
PROFESSIONAL: MINUTES
20
NOVICE (DIY): MINUTES
INSTALL NOTES:
-NO DRILLING REQUIRED
-NO FASCIA TRIMMING REQUIRED
INSTALLATION STEPS
1. Raise hitch into position as shown. Slide the rear bracket over existing 14mm studs protruding from the
bumper. Do not remove existing 14mm nuts.
2. Push the hitch up to make contact with the floor rib of the vehicle. Install (2) 8mm bolts with washers and
lock washers into existing weldnuts.
3. Install (2)14mm nuts with lock washers onto existing studs at the bumper beam.
4. Torque all 14mm fasteners to 94 lb-ft, and all 8mm fasteners to 17 lb-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
24814 / 247103
JEEP SRT 8
DESCRIPTION
HEX NUT
HEX HEAD BOLT
LOCK WASHER
WASHER
LOCK WASHER
4
2,000 LBS. TRAILER WEIGHT &
1-800-798-0813
**CAUTION**
HITCH, BALL MOUNT, HITCH PIN AND HITCH PIN CLIP
MAY BECOME HOT DURING VEHICLE OPERATION.
USE CAUTION WHEN INSTALLING OR REMOVING
ANY BALL MOUNTS OR ACCESSORIES.
1
5
200 LBS. TONGUE WEIGHT.
DESIGNED FOR USE WITH
BALL MOUNT # D-221 / 45522