Table of Contents
Advertisement
This Owner's Guide provides specific operating
instructions for
your model. Use the freezer only as instructed in this Owner's
Guide. Before
starting
the freezer,
follow
these
important
first steps.
INSTALLATION
•
Choose a place that is near a grounded electrical outlet. DO
NOT use an extension
cord or an adapter plug.
•
For most efficient operation, the freezer should be located
where surrounding
temperatures
will not drop below 40°F
(5°C) or exceed 110°F (43°C).
•
Allow the following clearances for ease of installation, proper
air circulation, and electrical connections:
Sides
3/8 inch
Back & Top
1 inch
•
Do not block the toe grille on the lower front of your freezer.
Sufficient air circulation is essential for the proper operation
of your freezer.
A 1"(25mm)
- Refrigerator
-- Freezer
TO LEVEL FREEZER:
After discarding crating screws and wood base, use a carpenter's
level to level the freezer from front to back. Adjust the plastic
leveling feet in front, 1/2 bubble higher, so that the door closes
easily when left halfway open.
LEVELING
INSTRUCTIONS
FOR ALL
REFRIGERATOR
/
FREEZER PAIR:
•
Remove two leg levelers provided in literature bag. While
unit is lying on its back for wood skid removal, install both leg
levelers in rear of unit.
•
Level door of first unit using all four levelers and slide unit into
place. Recheck for levelness and adjust if necessary.
•
Measure distance from floor to bottom of door on first unit.
Adjust and level second unit so door height matches.
•
Leg Level Adjustments:
•
One full turn of all four leg levelers will raise door 5/32".
•
One full turn of both front leg levelers will raise door 3/16" and
tilt top of door back 7/16".
•
One full turn of both rear leg levelers will lower door 1/32" and
tilt top of door forward 7/16".
•
One full turn of both side leg levelers will raise door 3/16" and
tilt top of door 3/8".
•
Slide second unit into place leaving a minimum gap of 3/16"
between units for door swing clearance.
•
This last step may require at least one extraction of the second
unit to properly align units in a "built-in" application.
Lower
Leveling Feet
\\_\\\\
.
Discard
The (4) Crating Screws
And (2) Wood Bases
DOOR OPENING
NOTE: If your freezer is placed with the door hinge side against
a wall, you may have to allow additional space so the door can
be opened wider.
LEVELING
The freezer must have all bottom corners resting firmly on a solid
floor. The floor must be strong enough to support a fully loaded
freezer. It is VERY IMPORTANT for your freezer to be level in order
to function properly. If the freezer is not leveled during installation,
the door may be misaligned and not close or seal properly, causing
cooling, frost or moisture problems.
Shelf
Front
6
Advertisement
Table of Contents
