Installation - Kenmore 970F44853 Series Use & Care Manual

Installation

Required Tools:
Component Provided:
Hinge
Screw
This Use & Care Guide provides general
installation and operating instructions for
your model. We recommend using a service
or kitchen contracting professional to
install your appliance. Use the unit only as
instructed in this Use & Care Guide. Before starting the appliance, follow these important
first steps.
Location
• Choose a place that is near a grounded,
non-GFCI, electrical outlet. Do Not use an
extension cord or an adapter plug.
• If possible, place the unit out of direct
sunlight and away from the range,
dishwasher, or other heat sources.
• The appliance must be installed on a floor
that is level and strong enough to support
a fully loaded unit.
CAUTION
Do not install the appliance where the
temperature will drop below 55°F (13°C)
or rise above 110°F (43°C). The compressor
will not be able to maintain proper
temperatures inside the unit.
Do not block the kick plate on the lower
front of your appliance. Sufficient air
circulation is essential for the proper
operation of your unit.
Phillips™
Head or
#2 Square Drive
Head
OR
Socket
Wrench Set
Installation
Allow the following clearances for ease
of installation, proper air circulation, and
plumbing and electrical connections:
Sides & Top ⅜" (9.5 mm)
Back 1" (25.4 mm)
NOTE
If your appliance is placed with the door
hinge side against a wall, you may have
to allow additional space so the door can
be opened wider.
1"
(25 mm)
(10 mm)
6
(OR)
AND
OR
Adjustable ⅜" Fixed
Wrench Wrench
1" (25 mm)
Freezer
⅜"
⅜" (10 mm)