Troubleshooting - Hunter 21117 Owner's Manual And Installation Manual

Symptom
1.No functions operate.
2.Operates only at close range. Signal blocked from reaching
3.Inconsistent operation.
7 • Troubleshooting
Possible Causes
Main Power not restored.
Fan pull chain not set to High. Set fan pull chain to High speed.
Light pull chain not set to ON. Set light kit to ON.
Receiver wiring incorrect.
Transmitter and receiver DIP
switches do not match.
Battery too weak.
receiver.
Battery too weak.
Interference
Signal partially blocked from
reaching receiver.
RF interference.
Continuing RF interference.
41316-01 • 06/25/10 • Hunter Fan Company
Solution
Replace fuse. Turn ON circuit breaker. Turn ON wall switch.
Verify wiring connections.
Set transmitter and receiver to same DIP switch setting.
Replace with new, 9 Volt alkaline battery. Refer to
"Transmitter Installation", Section 6.
Extend antenna into ceiling box, or move it for better
reception.
Replace with new, 9 Volt alkaline battery. Refer to
"Transmitter Installation", Section 6.
Change the DIP switch settings on the remote receiver and
transmitter,
Extend antenna into ceiling box, or move it for better
reception.
Turn OFF wall switch for 5 seconds, then turn back ON.
Change DIP switch settings to a different code in both
transmitter and receiver.
10