Advertisement
Setup Instructions for Remote Control (146-59-1, 146-65-1, 146-78-1)
Troubleshooting
If the remote is still not connecting to the WinAlign console after several retries, refer to the steps below to
possibly identify a problem.
1. Verify XF pod or receiver board is connected to the PC. There should be a indicator light on the pod
showing that they are receiving power from the console.
2. Check to make sure that the remote control channel setting is set to "A,0" in "Remote Control Channel
Identification" under the "Aligner Equipment" heading in setup.
3. If the remote is still not connecting, it may be necessary to power down and unplug nearby WinAlign
consoles to remove interfering channels.
4. The batteries on the remote indicator may be dead and need to be replaced.
Compliance Statement
FCC
Changes or modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ISED
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's license-exempt RSS(s). Operation is subject to the following two condi-
tions:
Page 6 of 7
Advertisement
