Dip Switch Settings; Installation Instructions - Hunter 21117 Owner's Manual And Installation Manual

BEFORE INSTALLING THE CONTROL:
1. Use the pull chain switch to set the fan speed to the HIGH position before
installation. Do not use the pull chain to change the fan speed after
installation, as damage to your ceiling fan or universal control may result.
The speed of the fan should only be changed by the Hunter control.
2. Set the ceiling fan light kit to the ON position before installation. The light
level should only be changed by the Hunter control.

Installation Instructions:

1. Disconnect power to the ceiling fan and light kit at the main electrical panel. Remove fuse or move
circuit breaker to the OFF position.
2. IMPORTANT! Before installing this control, check the factory default DIP switch settings. Refer
to Figure 1. Be sure the DIP switch positions of the transmitters and receiver match, or the ceiling
fan will not function. Select different combinations of
dip switches to prevent mis-operation due to other
remote control fans.
3. IMPORTANT! If your ceiling fan light kit is using
incandescent bulbs, then slide the CFL / INC switch
to the INC position. If your ceiling fan light kit is using
compact fluorescent light bulbs (CFL), then slide the
CFL / INC switch to the CFL position. NOTE: When
the switch is in the CFL position, the dimming feature
is disabled, and you will not be able to dim the light
bulbs. This feature is to protect both your bulbs and
your receiver as CFL bulbs are not able to dim and
will malfunction if dimming is attempted.
3 • DIP Switch Settings
Figure 2
Transmitter DIP
Switches
41316-01 • 06/25/10 • Hunter Fan Company
Figure 1
Example DIP Switch Settings
Receiver
DIP Switches
Dip Switches
Set to 01110
Figure 3
Receiver DIP
Switches
4
Transmitter
DIP Switches
Dip Switches
Dip Switches
Set to 0111 Set to 0111
Set to 01001
Set to 01110