Troubleshooting Guide - Hunter ROAM XL Owners Manual And Programming Instructions

TROuBLEsHOOTING GuIdE

PROBLEM
Transmitter display is blank.
Can't access all the desired stations on the
transmitter.
Receiver doesn't beep 4 times after
plugging it into the SmartPort
Receiver won't respond to Transmitter.
Transmitter display stays on.
"ERR" message in controller display when
controller is in the run position.
Receiver does not receive signal from
remote held at close range.
Remote has short range.
26
CAusEs
Transmitter is Off.
Battery is dead.
Maximum station number is set wrong.
SmartPort is not connected properly.
.
®
Controller has no power.
Receiver and Transmitter addresses don't match.
Transmitter will turn off automatically.
SmartPort wiring leads have been extended
®
and are receiving electrical or radio interference.
Mismatch of addresses in transmitter and
receiver.
Check for interference causes.
sOLuTIONs
Press the MODE button for 5 seconds.
Replace battery.
See "Changing the Maximum Station."
Recheck SmartPort ® wiring.
Check controller power.
Relearn address at Receiver.
Wait approximately 5 minutes without pressing
any buttons. Transmitter will "fall asleep."
Replace lengthened wire with shielded cable
to reduce radio interference. Use Hunter
SRR-SCWH. See "Extending Wiring on
SmartPort Harness."
®
Reset address of receiver.
See "Maximizing Operating Range."