Hunter 21117 Owner's Manual And Installation Manual page 6

Hands
Free
Figure 7
4 • Receiver Installation
NOTE: Some fans may have considerable excess lead wire.
For easier canopy installation, cut the excess wire leaving
a minimum of 6 inches remaining. Restrip the fan lead
wires 1/2 inch. Place remaining excess wire into the ceiling
electrical box as needed.
Hunter Hands-Free™ Canopy: Connect wiring
as shown in Figure 7. Place receiver inside mounting
bracket. Extend antenna above the ceiling mounting bracket
(approximately 3–6˝).
Bracket Hanger: Starting with the antenna wire, slide
receiver inside mounting bracket. If a ground wire mounting
move ground wire and screw to an unused hole at the top
of the bracket or secure with a canopy mounting screw. The
41316-01 • 06/25/10 • Hunter Fan Company
screw prevents the receiver from sliding into the bracket,
bracket must remain properly grounded. Connect wiring
as shown in Figure 8. Extend antenna above the receiver
6
Bracket
Hanger
(approximately 5–8˝).
Figure 8